Revo REVDPTZ22-2 Bedienerhandbuch PDF herunterladen (Seite 35)

• VIEW ANGLE SETUP

VIEW ANGLE SETUP

PANNING RANGE

FLIP : 90°

TILT LIMIT : OFF

SAVE AND EXIT(ESC TO CANCEL)

FLIP: OFF, AUTO, 90°, 100°, 110°, 120°,

OFF: the dome camera moves until 90° vertically.

AUTO: When the camera reaches the floor directly above the moving object, it will stop. At

that time, release the Joystick instantly and pull it down again to run the auto-flip function.

When you use the panning range, we recommend using the flip mode to AUTO.

90°, 100°, 110°, 120° : allows the image to flip digitally when the camera moves over the

setting angle vertically.

TILT LIMIT:

This option has been designed to limit the view angle as there is some obstruction in

zooming out on specific area of the tilt angle.

ON: When this option is enabled, the range of the tilt angle will be limited to 10 degree.

This can prevent from obstruction or bad focus problem caused by the horizontal line of

the semi sphere in the bubble.

OFF: When this option is disabled, the range of the tilt angle will not be limited.

When you zoom out within the range of the tilt angle, you will see the horizontal line of

the semi sphere in the bubble.

PANNING RANGE

When the dome camera is installed near a wall, panning range can be limited by user.

PANNING RANGE SETUP

(CTRL KEY)

RIGHT LIMIT : 000.0

LEFT LIMIT : 000.0

ENABLE : OFF

SWAP : OFF

AUTO PAN : ON

SAVE AND EXIT(ESC TO CANCEL)

1. Place the dome camera under 90 degree vertically.

2. Set “RIGHT LIMIT” by pushing the Joystick to the right.

3. Set the left limit by pushing the Joystick to the left.

4. Set ENABLE to ON to use

To exchange the right and the left limit, set SWAP to ON.

To apply limits on the auto pan (endless panning), set AUTO PAN to ON.

NOTE: When the flip mode is 90°, 100°, 110° or 120° and you moves over 90° vertically, the

panning range operates in opposite side.

1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 47 48

Keine Kommentare

Revo REVDPTZ22-2 Bedienerhandbuch Seite 35